Hi Mate, replied your question in email.
Could you check:
-Pull the BL upgrade key from after BL programming is done (stop flashing)
-Ensure the switch in 3D mode when writting Arduino firmwares
Search found 7 matches
- 28 Oct 2020, 09:03
- Forum: CNC Miller Technical Support Forum
- Topic: Upgrade Rev 2.0
- Replies: 4
- Views: 10299
- 24 Aug 2020, 02:31
- Forum: CNC Miller Technical Support Forum
- Topic: Latest links to Docs, Firmwares, Softwares, FAQs
- Replies: 0
- Views: 19150
Latest links to Docs, Firmwares, Softwares, FAQs
PiBot Control Board (PI_CB) Docs - Upload the GRBL v1.1f Firmware for PiBot Control Board upload-grbl-1-1-firmware-for-picb-v1-0.pdf Software - LaserGRBL http://lasergrbl.com -Candle https://github.com/Denvi/Candle Firmwares (HW Rev 2.3) - USB Driver (only) [*] CH340 USB Driver win7, win8 and win10 ...
- 24 Aug 2020, 02:31
- Forum: Laser Engraver Technical Support Forum
- Topic: Latest links to Docs, Firmwares, Softwares, FAQs
- Replies: 0
- Views: 37620
Latest links to Docs, Firmwares, Softwares, FAQs
PiBot Control Board (PI_CB) Docs - Upload the GRBL v1.1f Firmware for PiBot Control Board upload-grbl-1-1-firmware-for-picb-v1-0.pdf Software - LaserGRBL http://lasergrbl.com -Candle https://github.com/Denvi/Candle Firmwares (HW Rev 2.3) - USB Driver (only) [*] CH340 USB Driver win7, win8 and win10 ...
- 19 Aug 2020, 04:41
- Forum: CNC Miller Technical Support Forum
- Topic: CNC Probing
- Replies: 5
- Views: 15447
Re: CNC Probing
Hi Mate, CNC Probing is an unbuffered direct input to the processor, and expect to use with an probing switch. If you like to use direct input like your diagram, would suggest: 1. Connect a pull-down resistor between S+ and GND, close to the controller board, a 10k Ohm resistor would does the job. T...
- 07 Aug 2020, 01:28
- Forum: CNC Miller Technical Support Forum
- Topic: CNC Probing
- Replies: 5
- Views: 15447
Re: CNC Probing
Hey Adam, could you please have more detail in the hardware and software you are using? Say the type of probe, to which port that been wired, the controller hardware version and firmware version, and the software and version. By having these information we can then reproduce your work condition and ...
- 05 Aug 2020, 08:38
- Forum: CNC Miller Technical Support Forum
- Topic: hello how are you?
- Replies: 3
- Views: 9291
Re: hello how are you?
Pretty good
- 05 Aug 2020, 08:37
- Forum: CNC Miller Technical Support Forum
- Topic: hello how are you?
- Replies: 3
- Views: 9291
Re: hello how are you?
All good