3d board config

Hardware Software Firmware Technical Support for 3D Printer.
Post Reply
Gabriele
Posts: 1
Joined: 05 Feb 2021, 17:37

3d board config

Post by Gabriele »

good morning
i would need to figure out if it is possible to configure the v2.3 motherboard with one motor for x one for y two for z and two for extruders.
Top
abcpibot
Posts: 7
Joined: 09 Dec 2020, 07:02

Re: 3d board config

Post by abcpibot »

you can config it in repetier firmware
Top
Alexbroad
Posts: 1
Joined: 11 Feb 2021, 18:50

Re: 3d board config

Post by Alexbroad »

Good morning buddy
Top
Post Reply

Return to “3D Printer Technical Support Forum”