Pauza button

[Svetko]

HI,
Greetings to all people of good will.
I am a beginner in this hobby so I need a little help:
Is it possible to connect a pulsant to the PiBot CNC rev2.3 that could put the CNC in a pause state.
Thanks in advance for any help.
Svetko

[abcpibot]

hi, dear sir, which position you would to put this equirment on?

[abcpibot]

You can control the pasue in the software, the board hardware connect only the enmergacy stop

[Svetko]

Thanks for your answer. I know that software can be used to pause. I was interested in whether a button for play, pause and stop can be placed on the board hardware Pibot v2.3, as CNC xPro v4 has (https://www.spark-concepts.com/cnc-xpro-v4-controller/)

[Svetko]

Thanks for your reply. I know the software can be used to pause. I was wondering if the play, pause and stop button could be placed on the hardware of the Pibot v2.3 board, as the CNC xPro v4 has (https://www.spark-concepts.com/cnc-xpro-v4-controller/)

[Svetko]

Thanks for your reply. I know the software can be used to pause. I was wondering if the play, pause and stop button could be placed on the hardware of the Pibot v2.3 board, as the CNC xPro v4 has (https://www.spark-concepts.com/cnc-xpro-v4-controller/)