Laser Engraver Rev2.0 User Manual and Troubleshooting -Old Page

Index

Simple Connect and Engrave Your Stuff

• 1 Install the USB Driver

• 2 Plug the USB data Cable and the USB Power Cable to PC

• 3 Unzip and Open the Software then AUTO Connect

• 4 Drop Images or Text to the Edit Zone，Select the Effect

• 5 Choose the Burnning Time.

• 6 Send to Machine.

• 7 Local the Engraving Area for the Object which will be engraved

• 8 Press Start and Waiting for Finish

 

Advanced Setting

• A Foucs the Light

• B Engraving Without PC

 

 

 

Connect and Engrave Your Stuff

 

Video

 

1 Install the USB Driver

Download -- https://www.pibot.com/pibot-laser-engraver-machine-rev2-0-usb-driver

 

2 Plug the USB data Cable and the USB Power Cable to PC

Or you can also plug the power cable to the 5V 1A(min)

Caution: DOT PLUG THE DATA AND THE POWER CABLE TO THE SAME USB HUB.

 

 

3 Unzip and Open the Software then AUTO Connect

Download -- https://www.pibot.com/pibot-laser-engraver-machine-rev2-0-software

Software would auto connect.

 

4 Drop Images or Text to the Edit Zone，Select the Effect

 

5 Choose the Burnning Time.

 

6 Send to Machine.

When you send to machine, means that your have send to the machine' rom, so you can also operate without PC

 

7 Local the Engraving Area for the Object which will be engraved

There are Three ways to local the postion. change it with up down left right :-)

Please test that, you will get the mean.

• Point Postioning

• To image center

• Position Box

 

8 Press Start and Waiting for Finish

The zone of red means that it have been engraved.

Caution: DO NOT DIRECTLY STARE AT THE LASER LIGHT, PLEASE USE THE SAFETY GLASS.

 

You can get the status in the software.

 

 

 

Advanced Setting

A Foucs the Light

 

B Engraving Without PC

When your “send image to machine” then your can operate the machine off-line